Deluxe 8-inch Grip (one) with stainless end cap – 61890



(One) Deluxe 8″ Grip for press arms, lat bars, curl bars, leg/ab seat bottoms, and leg press seat bottoms.  This is for a purchase of a single grip.  Measure the grip on your current equipment to make sure you purchase the correct size grip.

It is recommended that you replace both of the grips at the same time for the safety of your equipment.

Follow these directions at your own risk for a refreshed and new looking accessory:
To remove the old grip,  run a razor blade/box knife/utility knife down the grip and peal off like a banana.  Begin with the knife at the end of the grip closest to the center of the accessory.
Be careful not to damage the paint finish where you start your blade and where the new grip will reach when installed.  This can be measured by placing the new grip next to the bar.  All other nicks and scratches down the bar,  towards the end,  will be covered by the new grips.  Warm the grips to 80º F.   This is accomplished by placing the grips on a piece of foil in an oven at about 250 to 275 degrees for five to ten minutes.  Time can be adjusted up or down as needed for your oven.  You can feel the rubber get more pliable when squished between your thumb and forefinger.  CAUTION:  Wear leather gloves or other protection on your hands.   The stainless piece on the end of the grip is much hotter than the rubber.  Put about 5 pumps of non-aerosol hair spray inside the new handle.  This acts as a lubricant while wet, and as a glue when dry.  Immediately slide-push-pull the grip firmly into place.  You want to have some resistance while putting the new grip on.   This lets you know the new grip will stay in place for a very long time.  Quickly clean off any hair spray that may have dripped out.   If the grip isn’t warmed up, it won’t be installed successfully and won’t be able to be removed without being damaged.  Let the hair spray dry and the rubber come back to room temp before using.

See PN 13240 for lat bar inner 4″ long foam grip, PN 61910 6″ grip is not available at this time.  No replacement is available at this time.
See PN VFTLK for lat bar, PN 63540 for curl bar.

Additional information

Weight 1 lbs
Dimensions 8 × 3 × 3 in