Low Pulley/Leg Developer Cable – (No 10″ Extension) – 57800



Includes slit 3/4″Ø aluminum cable stop ball and set screw.
NOTE: REPLACES 55030 see part number 59840-EXT if you need to replace the entire length of your cable.  The  original cable was replaced with a 2 part cable system to help the user  with a known wear spot on the original design. Purchase PN 59840-EXT if you need the low pulley/leg developer cable with the low pulley 10″ extension  (47930)  cable included.

See the Tech Support tab on the home page to view extensive cable chart listing.
You can also purchase clear cable routing tube, PN 67910 to help with instalation if needed.

Install directions: Remove aluminum cable stop ball at leg developer with 1/8″ hex key, remove cable end at leg developer, connect clear tube to cable end at leg developer, pull out old cable at low pulley. Remove old cable. Connect new cable at low pulley and pull the clear tube back out at the leg developer. Reinstall cable stop ball and end at leg developer.

Cables are not returnable.

Additional information

Weight .5 lbs
Dimensions 7 × 5 × 1.75 in