Cable to the stack on: 1600, 1650 – 52740

$220.00

Description

Weight Stack Cable
This cable goes from weight stack through press arm to bottom of the tall column.
You should also order clear cable routing tube, PN 67910, to ease installation if the old cable can not be used for installing the new cable.

Install directions: Raise top plate and disconnect cable. Fully push on clear routing tube at this end. Pull out old cable at bottom of tall column through access door. Put new cable in place of old. Pull the clear tube back out at the weight stack. Reconnect the cable to the top plate.

*** Please take careful note:  If this cable is not installed correctly at pulley number 12, the cable will be damaged and need to be replaced quickly.   There is a “cable keeper” inside the metal bracket that holds pulley number 12.  Do not miss this keeper.  Please see the gallery pic for an example of the cable being installed incorrectly. The red arrow shows the weld mark for where the cable keeper is located inside the bracket.  You can see where the original cable rested in the correct position and you can also see that this cable is not installed correctly because it is rubbing against the frame.

Cables are not returnable.

Additional information

Weight 2 lbs
Dimensions 10 × 8 × 3 in