Bushing, Nylon Weight Plate – Black – 20620

Description

This listing is for ONE weight plate bushing.  There are two used for each weight plate except the top plate which uses 4.

To install bushings:

Turn weight plate over so you are looking at the bottom side of the plate.  Place on hard surface, but make sure the plate won’t be damaged by hard surface. A bath towel can be use between the plate and hard surface.

Place bushing on top of the hole with the curved edge down,

Hit the flat edge of your bushing with a dead blow hammer. It should take 3 or 4 hits to completely insert the bushing.

More part numbers for your reference:
PN 17080 Screw for guide rod top
PN 16520 Black nylon spacer for guide rod
PN 11340 Threaded guide rod insert
PN 26130 Rubber finish washer
PN 20660 “U” clip cable retainer
PN 29190 Screw to top plate and shaft
PN 60700 Top Plate
PN 60610 Current selector pin, used since 1/2005
PN 46700 Selector shaft 15 plates
PN 20630 Selector shaft 20 plates
PN 69600 Selector shaft 25 plates
PN 57670 under stack Bumpers come in a set of 2